Key Fob Programming

NOTE:

An erase programmed key fob procedure is provided within the wiTECH service tool. A Personal Identification Number (PIN) is required to erase original fobs. If programmed fobs are erased accidentally, then original programmed fobs can be reprogrammed to the SAME VIN ONLY. A pre-programmed fob cannot be reprogrammed to another VIN. A new blank fob obtained from MOPAR service can be added to a VIN only 1 time, and will remain mated to the VIN, even if the fob is erased from the VIN/RFHub, it can be reprogrammed.

NOTE:

Do not put a Laptop or other wireless device (cell phone, cell phone, audio device, etc.) on top of or near the center console (between the seats to the dash). The Low Frequency (LF) antenna is below the center console and these devices may interrupt programming. Make sure that the key fob that is being programmed is inside the car away from nearby consumer electronics. Disconnect aftermarket cell phone chargers before attempting to program the key fob. This vehicle may not always have a center console, but the key fobs still need to be held in the center of the vehicle between the driver and passenger seats.

Using TechCONNECT, obtain a Personal Identification Number (PIN) prior to starting the programming routine.

Sitting in the vehicle with the doors closed is a requirement for this routine to complete properly.

Using the diagnostic scan tool, select the Radio Frequency Hub (RFH).
Select the "Miscellaneous Functions" tab.
Select and run the "Program Ignition FOBIKs" procedure and follow the screen prompts.

If the key fob fails to program or is inoperative. Refer to: KEYFOB TRANSMITTER - DIAGNOSIS AND TESTING .