Diagnostic Test

CHECK FOR ACTIVE INTERNAL FAULTS, IGNITION FAULTS, AND BATTERY FAULTS IN THE OCCUPANT RESTRAINT CONTROLLER (ORC)
NOTE:
Make sure the battery is fully charged.
1. With the scan tool, read Occupant Restraint Controller (ORC) DTCs.
  Does the scan tool display any active DTCs relating to internal faults, ignition faults, or battery faults?
  
  Yes
  - Diagnose and repair the DTCs. Refer to OCCUPANT RESTRAINT CONTROLLER (ORC), DIAGNOSTIC CODE INDEX .
  No
  - Go To 2
VERIFY THAT DTC IS ACTIVE
1. With the scan tool, erase ORC DTCs.
2. Turn the ignition off, wait 10 seconds and then turn the ignition on.
3. Wait 2 minutes, and then with the scan tool, read ORC DTCs.
  Does the scan tool display active: B2734-95-PASSENGER OCCUPANT DETECTION SENSOR-INCORRECT ASSEMBLY?
  
  Yes
  - Go To 3
  No
  - Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to RESTRAINTS SYSTEM VERIFICATION TEST .
VERIFY SENSORS
1. Turn the ignition off.
2. Inspect the Passenger seat wiring for Seat Position Sensors.
  Are Seat Position Sensor present?
  
  Yes
  - Go To 4
  No
  - Replace the Occupant Restraint Controller (ORC) in accordance with Service Information. Refer to CONTROLLER, OCCUPANT RESTRAINT (ORC), REMOVAL AND INSTALLATION .
  - Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to RESTRAINTS SYSTEM VERIFICATION TEST .
VERIFY ORC PART NUMBER AND CONFIGURATION
1. With the scan tool verify the ORC part number and configuration.
  Is the ORC part number and configuration correct?
  
  Yes
  - Disconnect the Occupant Detection Sensor connector and tie wrap the connector to the wire harness.
  - Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to RESTRAINTS SYSTEM VERIFICATION TEST .
  No
  - Repair complete.
  - Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to RESTRAINTS SYSTEM VERIFICATION TEST .