Instrument Cluster Test 4B - Warning Light Fails To Light

NOTE: Perform INSTRUMENT CLUSTER TEST 4A before proceeding with this test. For connector terminal identification, refer to CONNECTOR IDENTIFICATION . For wiring diagrams, refer to WIRING DIAGRAMS . Perform, after each repair, VERIFICATION TEST VER-1A - VERIFICATION PROCEDURE .

CAUTION: Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.

Remove and inspect inoperative indicator light. Replace as needed. Visually inspect instrument cluster circuit board. Replace as needed. If circuit board is replaced, recalibrate gauges using scan tool.