Instrument Cluster Test 5C - Panel Lights Driver Circuit

NOTE: Perform INSTRUMENT CLUSTER TEST 5A before proceeding with this test. For connector terminal identification, refer to CONNECTOR IDENTIFICATION . For wiring diagrams, refer to WIRING DIAGRAMS . Perform, after each repair, VERIFICATION TEST VER-1A - VERIFICATION PROCEDURE .

CAUTION: Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.

Ensure parking lights are on. Using scan tool in voltmeter mode, measure voltage on junction block fuse No. 1. If voltage is 10 volts or less, replace junction block. If voltage is more than 10 volts, replace Body Control Module (BCM). BCM is located with junction block under driver's side instrument panel. See Figure .