Skis Verification Test
NOTE:
Sentry Key Immobilizer Module (SKIM) will only remain in secured access mode for 60 seconds. If incorrect unique Personal Identification Number (PIN) is entered 3 times, SKIM will be locked for one hour. Turn off all accessories and connect battery charger if necessary. To unlock SKIM, turn ignition on for one hour. When SKIM is locked, scan tool will display BUS +/- SIGNALS OPEN.
- Reconnect all previously disconnected components and connectors. Obtain vehicle's unique PIN assigned to SKIM from vehicle owner or manufacturer. Remove all test equipment and jumper wires. With the DRBIII(R), select Theft Alarm, Skim, Miscellaneous, then select desired procedure and follow steps displayed on DRBIII(R). If SKIM has been replaced, ensure all keys and remote transmitters to be used with vehicle are programmed into SKIM.
- With the DRBIII(R), clear all DTCs. Perform 5 ignition cycles (key on/key off) leaving key on for 90 seconds per key cycle. With the DRBIII(R), read SKIM DTCs. Are there any SKIM DTCs present? Repair is not complete. Perform appropriate test(s). See DIAGNOSTIC TROUBLE CODE DEFINITIONS table under DIAGNOSTIC TROUBLE CODE DEFINITIONS. If no SKIM DTCs are present, repair is complete.