LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2011 >> Durango Heat, AWD >> Repair and Diagnosis >> Engine Performance >> System >> DTCS P0580 To P1573 >> Diagnosis And Testing >> P0580-Speed Control Switch 1 Circuit Low >> Diagnostic Test
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Diagnostic Test

  1. CHECK FOR AN ACTIVE DTC 
    WARNING:

    Turn the ignition off disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

    WARNING:

    Do not place an intact non-deployed airbag face down on a hard surface, the airbag propels into the air if accidentally deployed. Failure to follow these instructions may result in possible serious or fatal injury.

    1. Turn the ignition on.
    2. With the scan tool, read DTCs

      Does the scan tool display this DTC as active?

      Yes 

        NOTE:

        Visually and physically inspect the wiring harness between the Speed Control Switch harness connector and the SCCM harness connector. Repair any damaged wires, connectors, and open/spread terminals. If harness is OK, proceed with test.

      • Replace the Speed Control Switch in accordance with the Service Information. Refer to SWITCH, SPEED CONTROL, REMOVAL .
      • Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .

      No