Rear Blower Motor Power Module - Installation

INSTALLATION





1. Position the rear blower motor power module (3) into the rear heater-A/C housing (1). Make sure the module retaining tabs are fully engaged to the housing.
2. Install the screw (2) that secures the rear blower motor power module to the rear heater-A/C housing. Tighten the screw to 2 Nm (17 in. lbs.).
3. Connect the wire harness connector (4) to the rear blower motor power module.
4. Install the right quarter trim panel Quarter Trim Panel - Installation.
5. Reconnect the negative battery cable.