Power Sliding Door Module - Installation

INSTALLATION






NOTE: Any time a power sliding door component is removed, replaced, door adjustment is performed or diagnostic trouble codes are addressed and erased, a learn cycle must be performed. The power sliding door learn cycle enables the power sliding door control module to learn or relearn critical information (travel limits, resistance to door travel, door position, etc.) which allows the system to perform properly and safely. Programming and Relearning for the appropriate procedure.

1. Position the power sliding door control module onto the drive assembly (2) and install the retaining screws (1).





2. Connect the power sliding door control module (1) electrical connectors (3).
3. Install the power sliding door drive assembly, Power Sliding Door Drive Assembly - Installation.
4. Connect the battery negative cable.
5. Perform the power sliding door learn cycle, Programming and Relearning.