Anti-Lock Brake System Module - Installation

INSTALLATION










CAUTION:
Do not to touch the sensor terminals on the HCU side or the contact pads on the ABM side as this may result in contamination and issues in the future.

1. Align components and install the ABM (1) on the HCU (2).










2. Install the four screws (1) attaching the ABM (2) to the HCU. Tighten the mounting screws to 3 Nm (27 in. lbs.).










CAUTION:
Before installing the ABM harness connector on the ABM, be sure the seal is properly installed in the connector.

3. Insert the ABM wiring harness connector (2) into the socket of the ABM (1) and close the cover, locking the connector in place.

4. Connect the negative cable on the battery negative post.

5. Hook up the scan tool to initialize the ABM and perform the following:

a. Clear any faults.

b. Perform the ABS Verification Test and road test the vehicle ABS Verification Test.