LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2021 >> Durango SXT Plus, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Electronic Control Modules (Service Information) >> Module, Blind Spot (BSM) >> Removal
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Module, Blind Spot (BSM): Removal

NOTE:

The Blind Spot Module (BSM) mounting brackets are bonded to, and integral to, the back side of the rear bumper fascia.

  1. Disconnect and isolate the negative battery cable.
  2. Remove the rear bumper fascia from the vehicle. Refer to FASCIA, REAR, REMOVAL .
    GC0173648Courtesy of CHRYSLER GROUP, LLC
  3. From the back of the rear fascia, disconnect the wiring harness connector (2) from the BSM.
  4. Remove the fastener (1) from the right rearward BSM boss location.
  5. Slide the BSM out of the mounting bracket.
scientia non olet · About LEMON Manuals