Sensor Resistance Test
- Before testing sensor resistance, ensure pole piece-to-wheel speed sensor tip is clean. Check wheel sensor pole piece for damage. If damaged, replace sensor.
- Disconnect wheel speed sensor connector. Inspect sensor wiring harness for broken and pinched wires. Repair or replace as necessary. Using an ohmmeter, measure sensor resistance at the harness connector. See the WHEEL SPEED SENSOR RESISTANCE SPECIFICATIONS table. If resistance is not within specification, replace sensor. If resistance is within specification, go to GROUND CIRCUIT TEST heading below.
WHEEL SPEED SENSOR RESISTANCE SPECIFICATIONS
| Application | Ohms | ||
|---|---|---|---|
| Diamante | |||
| Front | 1400-2200 | ||
| Rear | 1300-2100 | ||
| Eclipse & Galant | 800-1200 | ||
| Expo, Summit Wagon & Colt Vista | |||
| AWD | 800-1200 | ||
| FWD | |||
| Front | 800-1200 | ||
| Rear | 550-800 | ||
| Stealth & 3000GT | |||
| AWD | 800-1200 | ||
| FWD | |||
| Front | 1400-2200 | ||
| Rear | 1300-2100 | ||