Starter Relay Test
NOTE:
Perform solenoid test before testing starter relay.
Locate and remove starter relay from connector. See Figure or Figure . On Concorde, Daytona, Dynasty, Fifth Avenue, Imperial, Intrepid, LeBaron Convertible/Coupe, New Yorker and Vision, starter relay is located within power distribution center. On all models, connect 12-volt power source to starter relay terminal No. 86 and ground terminal No. 85. See Fig 1 . Using ohmmeter, check continuity across starter relay terminals No. 30 and 87. If continuity is not present, replace starter relay.