LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Eagle >> 1993 >> Vision ESi >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 3.3L/3.5L >> Fault Code Tests >> Test FC-28C - Injector #6 Control Circuit
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test FC-28C - Injector #6 Control Circuit

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION . For appropriate wiring diagram, see WIRING DIAGRAMS  at end of article.
NOTE: It may be necessary to remove intake plenum in the following steps.
  1. Reconnect junction block connector No. 3. Disconnect injector No. 6 connector. Turn ignition on. Using DRB-II, actuate Auto Shutdown (ASD) relay. Place DRB-II in voltmeter mode.
  2. Using DRB-II, check voltage of injector No. 6, ASD output wire (Dark Green/Orange wire). If voltage is less than 10 volts, repair ASD output wire for an open. Perform TEST VER-2. If voltage is more than 10 volts, go to next step.
  3. Turn ignition off. Using an external ohmmeter, check resistance of injector driver No. 6 wire (Brown/Black wire) between junction block connector No. 1 (junction block side) and injector No. 6 connector.
  4. If resistance is more than 5 ohms, repair injector driver No. 6 wire for an open. Perform TEST VER-2. If resistance is less than 5 ohms, replace injector. Perform TEST VER-2.
scientia non olet · About LEMON Manuals