Test 60A - Repairing Seat Belt Lamp Problem

WARNING: This page is about a different car, the 1994 Chrysler LeBaron. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION. For wiring diagram, see WIRING DIAGRAMS . Perform TEST VER-1 after each repair.

CAUTION: Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.

Turn ignition switch to ON position. If seat belt warning lamp is off, go to TEST 60B. If seat belt warning lamp is on, wait 10 seconds. If seat belt warning is still on, go to TEST 60C. If seat belt warning lamp goes off, system is operating properly at this time.