Cable, Shift: Installation: Installation

NOTE:

Make sure the rubber grommet in the floor pan is fully seated to prevent water leaking into the passenger compartment.

Fig 1: Shifter Cable & Retaining Clip

Courtesy of CHRYSLER GROUP, LLC

Install the shifter cable to the vehicle
Install the shifter cable (2) to the retaining clip (1).

Fig 2: Shifter Cable Grommet
Courtesy of CHRYSLER GROUP, LLC
Push the shifter cable grommet through the floor from beneath the vehicle.
Lower the vehicle.
Seat the rubber grommet into the floor pan. Ensure that the grommet is fully engaged to the floor pan.
Install the shifter. Refer to SHIFTER, TRANSMISSION, INSTALLATION .

Fig 3: Shift Cable, Bracket & Tabs
Courtesy of CHRYSLER GROUP, LLC
Install the shift cable (1) to the bracket (2). Make sure the lock tab (3) on the shift cable is fully seated.
Connect the shift cable (1) to the transaxle manual valve lever.
Install the battery tray. Refer to TRAY, BATTERY, INSTALLATION .
Adjust the shifter cable. Refer to CABLE, SHIFT, ADJUSTMENTS .