Possible Causes
| Possible Causes |
|---|
| BODY CONTROL MODULE (BCM) DTCS |
| MODULE THAT SET THIS DTC |
| BODY CONTROL MODULE (BCM) |
WARNING:
On vehicles equipped with the high voltage system, you must thoroughly read and follow all High Voltage Safety procedures. In addition, before performing any diagnostic or service procedure near a high voltage component, you must perform the High Voltage Power Down. Refer to ELECTRIC VEHICLE CONTROL SYSTEM, STANDARD PROCEDURE . Failure to follow these instructions may result in possible serious or fatal injury.
NOTE: When performing any key-on procedure you must charge the 12 volt battery with a setting of 20 amps minimum or the High Voltage Battery could discharge below recommended manufacture specifications and destroy the battery cells.
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding.