Diagnostic Test

CHECK IF THE DTC IS ACTIVE
1. Turn the ignition on.
2. With the scan tool, read Electric Vehicle Control Unit (EVCU) DTCs.
  Is the status for this DTC Active?
  
  Yes
  - Go To 2
  No
  - Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to STANDARD PROCEDURE .
ELECTRIC VEHICLE CONTROL UNIT (EVCU)
1. Using the wiring diagram/schematic as a guide, inspect the power and ground wiring and connectors to the Electric Vehicle Control Unit (EVCU).
2. Look for any chafed, pierced, pinched or partially broken wires.
3. Look for broken, bent, pushed out or corroded terminals.
4. Perform any Technical Service Bulletins that may apply.
  Were there any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the EVCU VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Replace and program the Electric Vehicle Control Module (EVCU) in accordance with the Service Information. Refer to UNIT, ELECTRIC VEHICLE CONTROL (EVCU), REMOVAL .
  - Perform the EVCU VERIFICATION TEST. Refer to STANDARD PROCEDURE .