LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Fiat >> 2013 >> 500e >> Repair and Diagnosis (Single Page) >> Transmission >> Transmission Control Systems >> Electric Vehicle Control Unit (EVCU) Module - DTCS P1139 To U1487 - 500E >> Diagnosis And Testing >> P1C75-Reverse Switch 1 Circuit High >> Diagnostic Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Test

  1. CHECK IF DTC IS CURRENT 
    1. Using the scan tool, read EVCU DTCs.
    2. Record the Environmental Data and any DTCs.
    3. Clear DTCs.
    4. Using the recorded Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
    5. Read EVCU DTCs.

      Did the DTC reset?

      Yes 

      • Go To  2

      No 

  2. CHECK THE REVERSE LOW SIDE SWITCH (1) OPERATION 
    1. Using the scan tool, and the ePRND Typical Switch Voltage table, operate the Reverse Switch and note the voltage for Not Pressed and Pressed.

      Is the Reverse High Side Switch (1) higher than the voltage listed in the table for either switch position?

      Yes 

      • Go To  3

      No 

      • Using the schematics as a guide, check the Electric Vehicle Control Unit (EVCU) pins, terminals, and connectors for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace and program the EVCU in accordance with the Service Information. Refer to UNIT, ELECTRIC VEHICLE CONTROL (EVCU), REMOVAL .
      • Perform the EVCU VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  3. CHECK THE (T402) REVERSE LOW SIDE SWITCH (1) FOR A SHORT TO VOLTAGE 
    1. Turn the ignition off. Remove the key from the Ignition Switch, close doors and allow the EVCU to shut down.
      NOTE:

      Allow up to two minutes for the EVCU to shut down. Opening the vehicle door will interrupt the shut down process.

    2. Disconnect the ePRND harness connector.
    3. Ignition in the run position.
    4. Measure the voltage of the (T402) Reverse Low Side Switch (1) circuit at the ePRND harness connector.

      Is the voltage of the (T402) Reverse Low Side Switch (1) circuit above 0.5 of a volt?

      Yes 

      • Repair the (T402) Reverse High Side Switch (2) circuit for a short to voltage.
      • Perform the EVCU VERIFICATION TEST. Refer to STANDARD PROCEDURE .

      No 

      • Using the schematics as a guide, check the ePRND pins, terminals, and connectors for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the ePRND in accordance with the Service Information. Refer to SWITCH, ELECTRIC SHIFTER, REMOVAL .
      • Perform the EVCU VERIFICATION TEST. Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals