Diagnostic Test

PROGRAM THE POWERTRAIN CONTROL MODULE 

1. Verify the PCM is at the latest calibration (flash level).
   NOTE:

   An intermittent loss of power to the PCM without performing an ETC Relearn procedure may cause this DTC to set.

   NOTE:

   Diagnose any other DTCs that may have set with the P060B.

2. Program the PCM in accordance with the Service Information. and follow the PCM/ECM PROGRAMMING procedure. Refer to STANDARD PROCEDURE .
3. Start the engine.
4. Allow the engine to reach normal operating temperature.
5. Operate the accelerator pedal. (do not exceed 3500 rpm)
6. With the scan tool, select View DTCs.

   Does this DTC reset by itself?

   Yes 

   • Replace and reprogram the Powertrain Control Module (PCM) in accordance with the Service Information. Refer to MODULE, POWERTRAIN CONTROL, REMOVAL .
   • Perform the POWERTRAIN VERIFICATION TEST. Refer to STANDARD PROCEDURE .

   No 

   • Test Complete.