Diagnostic Test

RECORD AND ERASE ALL RESTRAINT SYSTEM DTCS
1. With the scan tool, record and erase all DTCs from all restraints system modules. Monitor for any active codes as you work through the following steps.
  - Review the code monitored and set conditions for any DTCs that are stored and attempt to reproduce the conditions listed.
    WARNING:
    Maintain a safe distance from all airbags while performing the following steps. Failure to follow these instructions may result in possible serious or fatal injury.
  - Wiggle the wiring harness and connectors of the related airbag circuit, sensor, or component.
    WARNING:
    Turn the ignition off disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
  - Disconnect components and inspect the harness and connectors for damage.
  - Reconnect components and ensure they are properly seated.
    WARNING:
    Turn the ignition on, then reconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
  - If codes are related to the Driver Airbag circuits, rotate the steering wheel from stop to stop.
  - Turn the ignition off.
  - Perform any Technical Service Bulletins (TSBs) that may apply.
  Was the source of the customer complaint found or did any DTCs appear and stay active?
  
  Yes
  - Make the appropriate repairs. Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to RESTRAINTS SYSTEM VERIFICATION TEST . For the appropriate diagnostic procedure. Refer to DIAGNOSTIC CODE INDEX .
  No
  - Go To 2
ATTEMPT TO REPRODUCE THE CONDITION
1. In the event the customer complaint cannot be duplicated due to an intermittent condition in the restraints system, the following may aid in attempting to reproduce the condition.
  WARNING:
  Turn the ignition off, disconnect the battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
  - Using the wiring diagram/schematic as a guide, inspect the wiring and connectors related to the stored code or component in question.
  - Look for chafed, pierced, pinched, or partially broken wires and broken, bent, pushed out, spread, corroded, or contaminated terminals.
  - Reconnect any disconnected components and harness connectors and ensure they are properly seated.
    WARNING:
    Turn the ignition on, then reconnect the battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
  - If numerous trouble codes were set, use a schematic and inspect any common ground or supply circuits.
  Was the source of the intermittent condition located?
  
  Yes
  - Make the appropriate repairs and perform the RESTRAINTS SYSTEM VERIFICATION PROCEDURE. Refer to RESTRAINTS SYSTEM VERIFICATION TEST .
  No
  - The problem cannot be found at this time.