Possible Causes
| Possible Causes |
|---|
| ELECTRIC VEHICLE CONTROL UNIT (EVCU) |
On vehicles equipped with the high voltage system, you must thoroughly read and follow all High Voltage Safety procedures. In addition, before performing any diagnostic or service procedure near a high voltage component, you must perform the High Voltage Power Down. Failure to follow these instructions may result in possible serious or fatal injury.
NOTE: When performing any key-on procedure you must charge the 12 volt battery with a setting of 20 amps minimum or the High Voltage Battery could discharge below recommended manufacture specifications and destroy the battery cells.
Refer to ELECTRIC VEHICLE CONTROL SYSTEM, STANDARD PROCEDURE to perform the High Voltage Power Down procedure.
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Refer to STANDARD PROCEDURE .
An open BPCM fuse can cause this DTC to set. Check the fuse before performing this diagnostic procedure. If the fuse is open, repair cause of open fuse, clear DTCs and verify proper vehicle operation.