Diagnostic Test

CHECK FOR INSTRUMENT PANEL MODULE ERRORS
1. Check for presence of Instrument Panel Module DTCs.
  Are there DTCs?
  
  Yes
  - Proceed as indicated by the diagnosis equipment.
  No
  - Go to Step 2.
CARRY OUT THE RESTORE PROCEDURE FOR INSTRUMENT PANEL MODULE CONFIGURATION
1. Connect the diagnosis equipment to the Instrument Panel Module and check whether the vehicle configuration resetting procedure has been carried out.
2. Perform the Blind Spot Module erase DTC procedure.
3. at least 31.5 seconds.
4. Check whether the DTC is still present.
  Is the DTC still present?
  
  Yes
  - Carry out the vehicle configuration restoration procedure again.
  - Go to Step 3.
  No
  - End of diagnosis.
CHECK CORRECT OPERATION OF THE BLIND SPOT MODULE, LEFT SIDE
1. Perform the Blind Spot Module erase DTC procedure.
2. at least 31.5 seconds.
3. Check whether the DTC is still present.
  Is the DTC still present?
  
  Yes
  - Replace the Blind Spot Module, left side.
  No
  - End of diagnosis.