Diagnostic Test

CHECK CONNECTION STATUS OF THE START BUTTON
1. Go to Key-OFF status.
2. Disconnect the start button connector.
3. Check state of connector and that the terminals are not damaged, deformed, corroded or disconnected.
  Is the connector intact?
  
  Yes
  - Go to Step 2.
  No
  - Repair or replace the connector, then move on to Step 4.
CHECK CONNECTION STATUS OF PASSIVE ENTRY NODE
1. Disconnect the Passive Entry node connector.
2. Check state of connector and that the terminals are not damaged, deformed, corroded or disconnected.
  Is the connector intact?
  
  Yes
  - Go to Step 3.
  No
  - Repair or replace the connector, then move on to Step 4.
CHECK FOR PERSISTENCE OF ERROR IN THE ELECTRONIC KEY
1. Restore the electrical connections.
2. Connect the negative battery lead.
3. With the scan tool, erase DTCs.
4. Reprogram the electronic key ID code.
5. Check whether the DTC is still present.
  Is the DTC still present?
  
  Yes
  - Replace the electronic key.
  - Go to Step 4.
  No
  - End of diagnosis.
CHECK FOR PERSISTENCE OF ERROR IN THE ELECTRONIC KEY
1. Restore the electrical connections.
2. Connect the negative battery lead.
3. With the scan tool, erase DTCs.
4. Reprogram the electronic key ID code.
5. Check whether the DTC is still present.
  Is the DTC still present?
  
  Yes
  - Repeat the checks from Step 1 .
  - Replace the Passive Entry Node if the DTC occurs again.
  No
  - End of diagnosis.