LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Fiat >> 2017 >> 124 Spider Classica, Automatic Trans >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> 1.4L - DTCS P2122-00 To U11E0-00 >> DTC Troubleshooting >> U0452-00-Implausible Data Received From Restraints Control Module >> Diagnostic Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Test

  1. CHECK FOR BCM CAN BUS DTCS 
    1. With the scan tool, read BCM DTCs.

      Are any BCM CAN BUS DTCs present?

      Yes 

      • Perform the appropriate diagnostic procedure.
      • Perform the diagnostic procedure for DTC U0001-CAN C BUS first if the fault is present. Refer to U0001-00-CAN C BUS .

      No 

      • Go To  2
  2. OCCUPANT RESTRAINT CONTROL (ORC) DTCS PRESENT 
    1. With the scan tool, read ORC DTCs.

      Are any DTCs present?

      Yes 

      • Perform the appropriate diagnostic procedure.

      No 

      • Go To  3
  3. CHECK RELATED PCM AND COMPONENT CONNECTIONS 
    1. Perform any Service Bulletins that apply.
    2. Disconnect all PCM harness connectors.
    3. Disconnect all related in-line harness connections (if equipped).
    4. Disconnect the related component harness connectors.
    5. Inspect harness connectors, component connectors, and all male and female terminals for the following conditions:
      • Proper connector installation.
      • Damaged connector locks.
      • Corrosion.
      • Other signs of water intrusion.
      • Weather seal damage (if equipped).
      • Bent terminals.
      • Overheating due to a poor connection (terminal may be discolored due to excessive current draw).
      • Terminals that have been pushed back into the connector cavity.
      • Check for spread terminals and verify proper terminal tension.

      Repair any conditions that are found.

    6. Reconnect all PCM harness connectors. Be certain that all harness connectors are fully seated and the connector locks are fully engaged.
    7. Reconnect all in-line harness connectors (if equipped). Be certain that all connectors are fully seated and the connector locks are fully engaged.
    8. Reconnect all related component harness connectors. Be certain that all connectors are fully seated and the connector locks are fully engaged.
    9. With the scan tool, erase DTCs.
    10. Test drive or operate the vehicle in accordance with the when monitored and set conditions.
    11. With the scan tool, read DTCs.

      Is the DTC active or pending?

      Yes 

      No 

      • Test complete.
scientia non olet · About LEMON Manuals