Diagnostic Test

CHECK FOR AN ACTIVE DTC
1. Turn the ignition on.
2. With the scan tool, read DTCs and record on the repair order.
3. With the scan tool, erase DTCs.
4. Start the engine and road test until it reaches normal operating temperature.
5. With the scan tool, read DTCs.
  Is the DTC active or pending?
  
  Yes
  - Go To 2
  No
  - Perform the INTERMITTENT CONDITION diagnostic procedure. INTERMITTENT CONDITION .
CHECK THE O2 SENSOR CIRCUIT FOR AN OPEN OR HIGH RESISTANCE
1. Turn the ignition off.
2. Disconnect the PCM C1 harness connector.
3. Measure the resistance of the O2 Sensor 1/1 Signal circuit between the O2 Sensor 1/1 harness connector (pin C) and the PCM harness connector (pin 86).
  Is the resistance below 3.0 Ohms?
  
  Yes
  - Go To 3
  No
  - Repair the O2 Sensor 1/1 Signal circuit for an open or high resistance.
  - Perform the POWERTRAIN VERIFICATION TEST. POWERTRAIN VERIFICATION TEST .
REPLACE THE O2 SENSOR AND RETEST FOR DTC
1. Reconnect the PCM C1 harness connector.
2. Replace the O2 Sensor and reconnect the harness connector.
3. With the scan tool, read DTCs.
4. Turn the ignition on.
5. With the scan tool, erase DTCs.
6. Start the engine and allow it to idle long enough for the O2 Sensor to enter closed loop operation.
7. With the scan tool, read DTCs.
  Is the DTC active or pending?
  
  Yes
  - Go To 4
  No
  - Repair is complete.
  - Perform the POWERTRAIN VERIFICATION TEST. POWERTRAIN VERIFICATION TEST .
CHECK RELATED PCM AND COMPONENT CONNECTIONS
1. Perform any Service Bulletins that apply.
2. Disconnect all PCM harness connectors.
3. Disconnect all related in-line harness connections (if equipped).
4. Disconnect the related component harness connectors.
5. Inspect harness connectors, component connectors, and all male and female terminals for the following conditions:
  - Proper connector installation.
  - Damaged connector locks.
  - Corrosion.
  - Other signs of water intrusion.
  - Weather seal damage (if equipped).
  - Bent terminals.
  - Overheating due to a poor connection (terminal may be discolored due to excessive current draw).
  - Terminals that have been pushed back into the connector cavity.
  - Check for spread terminals and verify proper terminal tension.
  Repair any conditions that are found.
6. Reconnect all PCM harness connectors. Be certain that all harness connectors are fully seated and the connector locks are fully engaged.
7. Reconnect all in-line harness connectors (if equipped). Be certain that all connectors are fully seated and the connector locks are fully engaged.
8. Reconnect all related component harness connectors. Be certain that all connectors are fully seated and the connector locks are fully engaged.
9. With the scan tool, erase DTCs.
10. Test drive or operate the vehicle in accordance with the when monitored and set conditions.
11. With the scan tool, read DTCs.
  Did the DTC return?
  
  Yes
  - Replace and program the Powertrain Control Module (PCM) in accordance with the Service Information. Refer to MODULE, POWERTRAIN CONTROL (PCM), REMOVAL AND INSTALLATION .
  - Perform the POWERTRAIN VERIFICATION TEST. POWERTRAIN VERIFICATION TEST .
  No
  - Perform the POWERTRAIN VERIFICATION TEST. POWERTRAIN VERIFICATION TEST .
  - Test complete.