Module, Transmission Control (TCM): Installation
- Clean any debris or contaminants to the connector area.
- Use the positive locating feature on the electrical connector to orient the Transmission Control Module (TCM) prior to installation.
- Install the TCM, tighten the fasteners to 25 Nm (18 lbf-ft).NOTE:
Do not turn the shaft more than 60 degrees to the marking, otherwise damage may occur.
- Be sure to match the position of the TCM markings (1).
- Connect the manual shift lever to the TCM (1), tighten the fastener to 16 Nm (12 lbf-ft)
- Connect the electrical connections to the TCM.
- Install the battery tray. Refer to INSTALLATION .
- Program the TCM.