Module, Fuel Pump: Removal
WARNING:
The fuel system may be under a constant pressure (even with the engine off). Before servicing the fuel pump module, the fuel system pressure must be released.
- Perform the fuel pressure release procedure. Refer to FUEL SYSTEM PRESSURE RELEASE .
- Disconnect and isolate the negative battery cable.
- Tilt the middle seat forward to gain access to the fuel pump.
- Remove the middle seat molded carpet. It will be necessary to spread the carpet open at the prop rods (1) and the seat latch anchors (2).
- Locate the fuel pump module access cover under the molded carpet.
- Remove the fuel pump module access cover (1) by removing the screws (2).
- Disconnect the fuel pump module wiring connector (4).
- Disconnect the fuel lines. Refer to FITTING, QUICK CONNECT, STANDARD PROCEDURE .
- Remove the fuel pump module locking ring (3) using SAE Fuel Pump Lock Ring Wrench (special tool #9340, SAE Fuel Pump Lock Ring Wrench) (2).
- Remove the fuel pump module (4) from the fuel tank and discard the seal (gasket).