LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Fiat >> 2018 >> 500L Pop >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Electronic Control Modules (Service Information) >> Module, Security Gateway (SGM) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Module, Security Gateway (SGM): Installation

NOTE:

If a NEW  Security Gateway (SGW) module is being installed, use the diagnostic scan tool to flash the module. Failure to flash the module will leave the SGW module in a locked mode preventing SGW module operation.

  1. Position the SGW module.
  2. Install the SGW module bolts and tighten the bolts securely.
  3. Connect the SGW module wire harness connectors.
  4. Install the driver Knee AirBag (KAB). Refer to AIR BAG, KNEE BLOCKER, INSTALLATION .
  5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
  6. If a NEW  SGW module is installed, use the diagnostic scan tool to flash the SGW module.
NOTE:

If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to determine if alignment of the PROXI configuration data into the new ECU is needed. If PROXI alignment is needed, follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under the Body Control Module (BCM) Miscellaneous Functions menu.

scientia non olet · About LEMON Manuals