Continuity Check
WARNING: This page is about a different car, the 1990 Ford Probe and 1989 Ford Probe. However, it is still accessible from the selected car via links, so may be relevant.
- Ensure ABS fail-safe relay is disconnected. Verify ignition is off.
- Set VOM on 20 k/ohm scale. Check resistance at ABS fail-safe relay between terminal "b" and terminal "c". Resistance should be greater than 10,000 ohms.
- Set VOM on 200 ohm scale. Check resistance at ABS fail-safe relay between terminal "b" and terminal "f". Resistance should be less than 5 ohms.
- If resistances are as specified, go to PINPOINT TEST FSR-8 . If resistances are not as specified, replace ABS fail-safe relay.