Ignition Switch: Service and Repair

Removal
1. Disconnect the battery ground cable.





2. Remove the instrument panel lower panel.
1. Remove the screws.
2. Release the fastener.





3. Detach the steering column upper shroud. Using a thin bladed screwdriver, release the two clips (one each side).





4. Remove the steering column lower shroud.
1. Release the steering column locking lever. (if equipped).
2. Remove the screws.
- Remove the ignition key.





5. Disconnect the electrical connectors.
- Disconnect the ignition switch electrical connector.
- Disconnect the turn signal/flash-to-pass switch electrical connector.





6. Remove the ignition switch.
- Release the clips.

Installation
1. To install, reverse the removal procedure.