Test F: Set/ACCEL Switch Inoperative

Turn ignition switch to LOCK position. Disconnect Black 10-pin speed control servo/actuator harness connector C136. Speed control servo/actuator is located behind left front fenderwell. Using DVOM, measure resistance between speed control servo/actuator harness connector C136 terminals No. 5 (Light Blue/Black wire) and No. 6 (Dark Green/Orange wire). See Figure . When pressing SET/ACCEL button, resistance should be 612-748 ohms. If resistance is as specified, replace speed control servo/actuator. See REMOVAL & INSTALLATION  . If resistance is not as specified, replace speed control switch.