Activating System (Aztek & Rendezvous)

Remove key from ignition switch. Ensure SIR fuse is still removed from fuse block. In reverse order, connect SIR component Yellow SIR connectors to vehicle harness and install CPA clips. Install SIR fuse in fuse block. Staying away from both air bags, turn ignition switch to ON position. Ensure AIR BAG warning light flashes 7 times, and then turns off. To complete installation, reverse removal procedures.

Fig 1: Locating Right Side Impact Sensor, Left Side Is Similar (Aztek & Rendezvous)

Courtesy of GENERAL MOTORS CORP.

Fig 2: Locating Driver Air Bag Yellow 2-Pin Connector (Aztek & Rendezvous)

Courtesy of GENERAL MOTORS CORP.

Fig 3: Locating Side Air Bag Yellow 2-Pin Connector (Aztek & Rendezvous)

Courtesy of GENERAL MOTORS CORP.