LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2003 >> ZX2 Standard >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Remote Keyless Entry Systems >> Component Tests >> Door Lock/Unlock Relay
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Door Lock/Unlock Relay

  1. Remove door lock/unlock relay. Door lock/unlock relay is located behind passenger's kick panel. Measure resistance between door lock/unlock relay (component side) terminal No. 5, and terminals No. 2, 4, 7 and 9. See Fig 1 . All resistances should be 150-185 ohms. If resistances are as specified, go to next step. If resistances are not as specified, replace door lock/unlock relay.
  2. Measure resistance between door lock/unlock relay (component side) terminal No. 6 and terminals No. 3, 8 and 12. All resistances should be less than 5 ohms. If resistances are as specified, go to next step. If resistances are not as specified, replace door lock/unlock relay.
  3. Apply battery voltage to specified door lock/unlock relay (component side) terminal and ground specified door lock/unlock relay (component side) terminal. See DOOR LOCK/UNLOCK RELAY TEST TERMINAL  table. Voltage in all test circuits should be more than 10 volts. If voltage is not as specified, replace door lock/unlock relay. If all voltages are as specified, relay is functioning properly.
    TESTING DOOR LOCK/UNLOCK RELAY TEST

    Apply Battery Voltage To Terminal No. Ground Terminal No.
    4 3
    6 2
    7 1
    9 8
Fig 1: Identifying Door Lock/Unlock Relay Terminals (Component Side)
G97H28065Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals