LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2011 >> Edge SE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2128 (Engine Controls - Fuel Charging And Controls - 3.7L) >> Removal And Installation >> Fuel Pump Control Module >> Removal and Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal and Installation

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Disconnect the Fuel Pump Control Module (FPCM) electrical connector.
  3. NOTE: Do not overtighten the fasteners or damage to the module may occur.

    Remove the 2 FPCM  bolts.

    • To install, tighten to 5 Nm (44 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals