DTC Chart: Remote Function Actuator (RFA) Module

Diagnostics in this information assume a certain skill level and knowledge of Ford-specific diagnostic practices.

RFA DTC CHART

DTC	Description	Action
B102B:00	Passive Key: No Sub Type Information	REFER to: PASSIVE ANTI-THEFT SYSTEM (PATS)
B102B:05	Passive Key: System Programming Failure	Less than 2 keys are programmed. PROGRAM additional keys (minimum of 2 keys must be programmed). REFER to: KEY PROGRAMMING USING DIAGNOSTIC EQUIPMENT
B10C1:24	Left Front Unlock Pull Switch: Signal Stuck High	REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS
B10C2:24	Left Rear Unlock Pull Switch: Signal Stuck High	REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS
B10C3:24	Right Front Unlock Pull Switch: Signal Stuck High	REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS
B10C4:24	Right Rear Unlock Pull Switch: Signal Stuck High	REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS
B10C5:24	Trunk Unlock Pull Switch: Signal Stuck High	REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS
B10C6:1F	Exterior Trunk Antenna: Circuit Intermittent	REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS
B10C7:1F	Interior Trunk Antenna: Circuit Intermittent	REFER to: PASSIVE ANTI-THEFT SYSTEM (PATS)
B10C8:1F	Interior Centre Antenna: Circuit Intermittent	REFER to: PASSIVE ANTI-THEFT SYSTEM (PATS)
B10C9:1F	Interior Front Antenna: Circuit Intermittent	REFER to: PASSIVE ANTI-THEFT SYSTEM (PATS)
B10CA:1F	Left Door Handle Antenna: Circuit Intermittent	REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS
B10CB:1F	Right Door Handle Antenna: Circuit Intermittent	REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS
B10D1:24	Left Front Lock button: Signal Stuck High	REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS
B10D3:24	Right Front Lock button: Signal Stuck High	REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS
B11CC:51	Immobilizer Keyless Vehicle Secret Key: Not Programmed	There is no BCM ID stored in the RFA module. CARRY OUT a parameter reset, then CYCLE the ignition and make an attempt to start the vehicle. REFER to: PASSIVE ANTI-THEFT SYSTEM (PATS) PARAMETER RESET
B1361:00	Front Right Door Handle Lock Circuit: No Sub Type Information	REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS
B1365:00	Front Left Door Handle Lock Circuit: No Sub Type Information	REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS
B1367:00	Right Rear Door Handle Unlock Circuit: No Sub Type Information	REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS
B136F:00	Left Front Door Handle Unlock Circuit: No Sub Type Information	REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS
B1370:23	Door Handle Ground Supply: Signal Stuck Low	REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS
B1370:24	Door Handle Ground Supply: Signal Stuck High	REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS
B1372:00	Left Rear Door Handle Unlock Circuit: No Sub Type Information	REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS
B1373:00	Front Right Door Handle Unlock Circuit: No Sub Type Information	REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS
B1399:00	Personalized Key Synchronization: No Sub Type Information	ERASE and program all of the customer's keys. REFER to: KEY PROGRAMMING USING DIAGNOSTIC EQUIPMENT or REFER to: KEY PROGRAMMING USING TWO PROGRAMMED KEYS
U0010:00	Medium Speed CAN Communication Bus: No Sub Type Information	The module cannot communicate on the network at a point in time. The fault is not currently present (the module had to communicate with the scan tool to report this DTC). VERIFY the integrity of the connectors and wiring. Refer to SYSTEM WIRING DIAGRAMS for additional information. If no faults are found, INSTALL a new RFA module. REFER to: Remote Function Actuator (RFA) Module
U0140:00	Lost Communication With Body Control Module: No Sub Type Information	GO to PINPOINT TEST A
U0300:00	Internal Control Module Software Incompatibility: No Sub Type Information	CLEAR the DTCs and REPEAT the self-test. If the DTC is retrieved again, INSTALL a new RFA module. REFER to: Remote Function Actuator (RFA) Module
U201B:54	Control Module Calibration Data #2: Missing Calibration	CHECK the vehicle service history for recent service actions related to this module. This DTC sets due to incomplete or incorrect Programmable Module Installation (PMI) procedures. If there have been recent service actions with this module, REPEAT the Programmable Module Installation (PMI) procedure as directed by the scan tool. REFER to: MODULE CONFIGURATION - SYSTEM OPERATION AND COMPONENT DESCRIPTION If there have been no recent service actions, INSTALL a new RFA module. REFER to: Remote Function Actuator (RFA) Module
U201F:00	External Receiver: No Sub Type Information	REFER to: PASSIVE ANTI-THEFT SYSTEM (PATS)
U201F:13	External Receiver: No Sub Type Information	REFER to: PASSIVE ANTI-THEFT SYSTEM (PATS)
U201F:87	External Receiver: Missing Message	REFER to: PASSIVE ANTI-THEFT SYSTEM (PATS)
U2100:00	Initial Configuration Not Complete: No Sub Type Information	CHECK the vehicle service history for recent service actions related to this module. This DTC sets due to incomplete or incorrect Programmable Module Installation (PMI) procedures. If there have been recent service actions with this module, REPEAT the Programmable Module Installation (PMI) procedure as directed by the scan tool. REFER to: MODULE CONFIGURATION - SYSTEM OPERATION AND COMPONENT DESCRIPTION If there have been no recent service actions, INSTALL a new RFA module. REFER to: Remote Function Actuator (RFA) Module
U2101:00	Control Module Configuration Incompatible: No Sub Type Information	CHECK the vehicle service history for recent service actions related to this module. This DTC sets due to incomplete or incorrect Programmable Module Installation (PMI) procedures. If there have been recent service actions with this module, REPEAT the Programmable Module Installation (PMI) procedure as directed by the scan tool. REFER to: MODULE CONFIGURATION - SYSTEM OPERATION AND COMPONENT DESCRIPTION If there have been no recent service actions, INSTALL a new RFA module. REFER to: Remote Function Actuator (RFA) Module
U3000:49	Control Module: Internal Electronic Failure	INSTALL a new RFA module. REFER to: Remote Function Actuator (RFA) Module
U3002:81	Vehicle Identification Number: Invalid Serial Data Received	CHECK the vehicle service history for recent service actions related to this module. This DTC sets due to incomplete or incorrect Programmable Module Installation (PMI) procedures. If there have been recent service actions with this module, REPEAT the Programmable Module Installation (PMI) procedure as directed by the scan tool. REFER to: MODULE CONFIGURATION - SYSTEM OPERATION AND COMPONENT DESCRIPTION If there have been no recent service actions, INSTALL a new RFA module. REFER to: Remote Function Actuator (RFA) Module
U3003:62	Battery Voltage: Signal Compare Failure	GO to PINPOINT TEST B