LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2014 >> Escape S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Cooling System - 1.6L) >> Diagnosis And Testing >> Engine Cooling >> DTC Chart >> PCM DTC Chart
April 5, 2026: LEMON Manuals is launched! Read the announcement.

PCM DTC Chart

WARNING: This page is about a different variant/trim than selected.
DTC Description Action
P0125 Insufficient Coolant Temp For Closed Loop Fuel Control Go to PINPOINT TEST C 
P0128 Coolant Thermostat (Coolant Temp Below Thermostat Regulating Temperature) Go to PINPOINT TEST C 
P0217 Engine Coolant Overtemperature Condition Go to PINPOINT TEST B 
P0480 Fan 1 Control Circuit Refer to ENGINE CONTROLS - INTRODUCTION (EXCEPT DIESEL & HYBRID) (SECTION 0) .
P1299 Cylinder Head Overtemperature Protection Active Sets in the PCMPCM when a cooling system fault was detected. A failure mode effects management strategy called fail-safe cooling was activated to protect the engine. Diagnose all other DTC's first. If no other DTC's are present. Go to PINPOINT TEST B 
P1940 Engine Coolant Level Signal Not Available Due To Driving Conditions Engine Coolant Level Signal Not Available Due To Driving Conditions
P2556 Engine Coolant Level Sensor/Switch Circuit Sets when there is an internal sensor fault. The sensor is still communicating on the CAN bus, but is unable to detect coolant level due to the internal circuit fault. INSTALL a new coolant stand-pipe.
P2557 Sets when there is an internal sensor fault. The sensor is still communicating on the CAN bus, but is unable to detect coolant level due to the internal circuit fault. INSTALL a new coolant stand-pipe. Sets when the coolant level signal is irrational or noisy (rapid change) for a calibrated time. Inspect the upper and lower stand pipe hoses for being kinked. If the hoses are not kinked clear the PCM DTCs and repeat the PCM self test. If the DTC is still present INSTALL a new coolant stand-pipe.
P2560 Engine Coolant Level Low Sets when the coolant level is below a calibrated threshold between empty and the MIN and MAX lines. Diagnose the cause of loss of coolant. Go to PINPOINT TEST A .
P2681 Engine Coolant Bypass Valve "A" Control Circuit/Open Refer to: TRANSMISSION COOLING .
P26AC Engine Coolant Bypass Valve "B" Control Circuit/Open Refer to: TRANSMISSION COOLING .
P26B7 Engine Coolant Bypass Valve "C" Control Circuit/Open Go to PINPOINT TEST D 
P26BD Engine Coolant Bypass Valve "D" Control Circuit/Open Go to PINPOINT TEST E 
All Other PCM  Diagnostic Trouble Codes (DTCs) - Refer to: ELECTRONIC ENGINE CONTROLS .