Information System And Entertainment System DTCS (Am/Fm/Cd/Sync/Touchscreen): FCIM

DTC INDEX

DTC	Description	Action
U0009:88 (Sony® FCIM only)	High Speed CAN Communication Bus (-) Shorted to Bus (+): Bus off	The module was unable to communicate on the network at a point in time. The fault is not currently present (the module had to communicate with the diagnostic scan tool to report this DTC . VERIFY the integrity of the connectors and wiring.
U0155:00 (Sony® FCIM only)	Lost Communication With Instrument Panel Cluster (IPC) Control Module: No Sub Type Information	GO to PINPOINT TEST AE
U0155:87 (Non-branded FCIM only)	Lost Communication With Instrument Panel Cluster (IPC) Control Module: Missing Message	GO to PINPOINT TEST AF
U0257:00 (Sony® FCIM only)	Lost Communication With Front Controls/Display Interface Module: No Sub Type Information	NOTE: Despite the description, this DTC applies to the FDIM , not the FCDIM . GO to PINPOINT TEST AK
U0257:87 (Non-branded FCIM only)	Lost Communication With Front Controls/Display Interface Module: Missing Message	NOTE: Despite the description, this DTC applies to the FDIM , not the FCDIM GO to PINPOINT TEST AL
U0423:00 (Sony® FCIM only)	Invalid Data Received From Instrument Panel Cluster Control Module: No Sub Type Information	RETRIEVE and FOLLOW Diagnostic Trouble Codes (DTCs) present in the IPC . REFER to: INSTRUMENTATION, MESSAGE CENTER AND WARNING CHIMES .
U2013:63	Switch Pack: Circuit/Component Protection Time-Out	CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds. REPEAT the self-test. If DTC U2013:63 is retrieved again, INSTALL a new FCIM . REFER to: FRONT CONTROLS INTERFACE MODULE (FCIM) .
U201A:51 (Non-branded FCIM only)	Control Module Main Calibration Data: Not Programmed	This DTC sets due to incomplete or incorrect PMI procedures. CHECK the vehicle service history for recent service actions related to the ACM . If there have been recent service actions with the FCIM , REPEAT/PERFORM the PMI procedure as directed by the diagnostic scan tool. REFER to: MODULE CONFIGURATION - SYSTEM OPERATION AND COMPONENT DESCRIPTION . See PMI . If there have been no recent service actions, INSTALL a new FCIM to correct the failure to retain configuration data. REFER to: FRONT CONTROLS INTERFACE MODULE (FCIM) .
U3000:41	Control Module: General Checksum Failure	CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:41 is retrieved again, INSTALL a new FCIM . REFER to: FRONT CONTROLS INTERFACE MODULE (FCIM) .
U3000:42	Control Module: General Memory Failure	CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:42 is retrieved again, INSTALL a new FCIM . REFER to: FRONT CONTROLS INTERFACE MODULE (FCIM) .
U3003:16	Battery Voltage: Circuit Voltage Below Threshold	GO to PINPOINT TEST AM
U3003:17	Battery Voltage: Circuit Voltage Above Threshold	GO to PINPOINT TEST AN