Front Controls Interface Module (FCIM)

DTC INDEX

DTC	Description	Action
U0009:88	High Speed CAN Communication Bus (-) shorted to Bus (+): Bus off	The module was unable to communicate on the network at a point in time. The fault is not currently present (the module had to communicate with the scan tool to report this DTC . VERIFY the integrity of the connectors and wiring.
U0155:00	Lost Communication With IPC Control Module: No Sub Type Information	GO to PINPOINT TEST AC
U0257:00	Lost Communication With Front Control/Display Interface Module: No Sub Type Information	NOTE: Despite the description, this DTC applies to the FDIM , not the FCDIM GO to PINPOINT TEST AF
U0423:00	Invalid Data Received From Instrument Panel Cluster Control Module: No Sub Type Information	RETRIEVE and FOLLOW Diagnostic Trouble Codes (DTCs) present in the IPC . REFER to: INSTRUMENTATION, MESSAGE CENTER AND WARNING CHIMES .
U2013:63	Switch Pack: Circuit/Component Protection Time-Out	GO to PINPOINT TEST J
U3000:41	Control Module: General Checksum Failure	CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:41 is retrieved again, INSTALL a new FCIM . REFER to: FRONT CONTROLS INTERFACE MODULE (FCIM) .
U3000:42	Control Module: General Memory Failure	CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:42 is retrieved again, INSTALL a new FCIM . REFER to: FRONT CONTROLS INTERFACE MODULE (FCIM) .
U3003:16	Battery Voltage: Circuit Voltage Below Threshold	GO to PINPOINT TEST AH
U3003:17	Battery Voltage: Circuit Voltage Above Threshold	GO to PINPOINT TEST AI