RFA Module
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| B10C7:01 | Interior Trunk Antenna: General Electrical Failure | GO to Pinpoint Test A . |
| B10C8:01 | Interior Centre Antenna: General Electrical Failure | GO to Pinpoint Test A . |
| B10C9:01 | Interior Front Antenna: General Electrical Failure | GO to Pinpoint Test A . |
| B10D7:05 | PATS Key: System Programming Failure | GO to Pinpoint Test D . |
| B10D8:51 | PATS Key Less Than Minimum Programmed: Not Programmed | If other PATS DTCs are present, address them first. If DTC B10D8:51 is the only DTC present, PROGRAM additional keys (minimum of 2 keys must be programmed). REFER to Key Programming Using Diagnostic Equipment . |
| B10D9:11 | PATS Transponder: Circuit Short to Ground | GO to Pinpoint Test E . |
| B10D9:12 | PATS Transponder: Circuit Short to Battery | GO to Pinpoint Test E . |
| B10D9:31 | PATS Transponder: No Signal | GO to Pinpoint Test E . |
| B10D9:87 | PATS Transponder: Missing Message | GO to Pinpoint Test E . |
| B10DA:51 | PATS Target Identifier: Not Programmed | There is no PCM identification stored in the RFA module. CARRY OUT a parameter reset, then CYCLE the ignition and make an attempt to start the vehicle. REFER to Passive Anti-Theft System (PATS) Parameter Reset . |
| B10DA:61 | PATS Target Identifier: Signal Calculation Failure | There is an incorrect PCM ID stored in the RFA module. CARRY OUT a parameter reset, then CYCLE the ignition and make an attempt to start the vehicle. REFER to Passive Anti-Theft System (PATS) Parameter Reset . |
| U201F:31 | External Receiver: No Signal | REFER to Handles, Locks, Latches and Entry Systems . |
| All other DTCs | - | REFER to the RFA module DTC Chart in Multifunction Electronic Modules . |