September 30: LEMON manuals is back up on a temporary server! Slowness is possible
Torque Converter Housing: Disassembly
- 1.
Special Tool(s): Remover/Installer, Front Wheel Hub 204-069, Transfer Gear Bearing Race Remover 307-577
 Courtesy of FORD MOTOR COMPANY
|
- 2.
 Courtesy of FORD MOTOR COMPANY
|
- 3.
Punch a hole in the fluid dam. Center punch.
 Courtesy of FORD MOTOR COMPANY
|
- 4.
General Equipment: Dent Puller
 Courtesy of FORD MOTOR COMPANY
|
- 5.
Special Tool(s): Differential Bearing Cup Remover 307-586
- 1.
Position the Differential Bearing Cup Remover 307-586 in the torque converter housing with the tabs on the Differential Bearing Cup Remover 307-586 aligned with the slots in the torque converter housing.
- 2.
Expand the Differential Bearing Cup Remover 307-586 by hand.
- 3.
While holding the Differential Bearing Cup Remover 307-586 in the expanded position with the tabs in the slots of the torque converter housing, tighten the nut.
 Courtesy of FORD MOTOR COMPANY
|
- 6.
General Equipment: Shop Press
 Courtesy of FORD MOTOR COMPANY
|
- 7.
 Courtesy of FORD MOTOR COMPANY
|