Pinpoint Test E : The Traction Control System Cannot Be Disabled
- E1 VERIFY THAT THE KEY IN USE IS NOT RESTRICTED
- For vehicles equipped with push-button start,
- place 1 passive key inside the vehicle and all other passive keys at least 1 meter (3 feet) away from the vehicle.
- press the start button without pressing the brake pedal.
- For vehicles not equipped with push-button start, turn the ignition to the ON position.
- Monitor the message center.
Does the message center display MYKEY ACTIVE DRIVE SAFELY?
Yes The current passive key or IKT is a restricted key and is functioning correctly.REPEAT the test using different passive keys or Integrated Keyhead Transmitters (IKTs) until the message center does not display MYKEY ACTIVE DRIVE SAFELY. GO to No GO to E2 - For vehicles equipped with push-button start,
- E2 VERIFY THE MYKEY ® TRACTION CONTROL SETTING
- Using the message center, verify the MyKey ® traction control setting. Refer to the Owner's Literature for information on setting the MyKey ® functions.
Is the MyKey ® traction control setting configured to "always on"?
Yes GO to E3 No GO to E4 - E3 VERIFY THE TRACTION CONTROL FUNCTION CAN BE DISABLED USING THE ADMIN KEY
- Using the message center, verify the traction control function can be enabled and disabled using the passive admin key or IKT admin key. Refer to the Owner's Literature for information on enabling and disabling the traction control function.
Can the traction control function can be enabled and disabled using the passive admin key or IKT admin key?
Yes The system is operating correctly at this time. The concern was most likely caused by the use of a restricted passive key or restricted IKT.INFORM the customer that traction control function can only be disabled using a passive admin key or an IKT admin key when the MyKey ® traction control setting is configured to "always on". No GO to E4 - E4 CHECK FOR ABS (ANTI-LOCK BRAKE SYSTEM) MODULE DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a diagnostic scan tool, carry out the ABS module self-test.
- Retrieve and record all ABS module Diagnostic Trouble Codes (DTCs).
Are there any ABS module Diagnostic Trouble Codes (DTCs) present?
Yes GO to the DTC Chart: ABS Module.REFER to: Anti-Lock Brake System (ABS) and Stability Control . No GO to E5 - E5 CHECK FOR IPC (INSTRUMENT PANEL CLUSTER) DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a diagnostic scan tool, carry out the IPC self-test.
- Retrieve and record all IPC Diagnostic Trouble Codes (DTCs).
Are there any IPC Diagnostic Trouble Codes (DTCs) present?
Yes GO to the DTC Chart: IPC.REFER to: Instrumentation, Message Center and Warning Chimes . No GO to E6 - E6 CHECK FOR GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a diagnostic scan tool, carry out the GWM self-test.
- Retrieve and record all GWM Diagnostic Trouble Codes (DTCs).
Are there any GWM Diagnostic Trouble Codes (DTCs) present?
Yes GO to the DTC Chart: GWM.REFER to: Communications Network (418-00 Module Communications Network). No The system is operating correctly at this time. The concern may have been caused due to high network traffic or an intermittent fault condition.