A/C Request

When an A/C request is received by the PCM, the PCM engages the A/C clutch relay when all of the following conditions are met:

• the refrigerant pressure is not excessively high or low.
• the engine coolant temperature is not excessively high.
• the ambient air temperature is above approximately 0°C (32°F).
• a WOT condition is not present.
• the evaporator discharge air temperature is above approximately 1°C (33.8°F).

The PCM monitors the discharge pressure measured by the A/C pressure transducer. The PCM interrupts A/C compressor operation in the event the A/C pressure transducer indicates high system discharge pressures. It is also used to sense low charge conditions. If the pressure is below a predetermined value for a given ambient temperature, the PCM does not allow the A/C clutch to engage.

The FCIM adjusts the air inlet door depending on the humidity measured by the in-vehicle temperature and humidity sensor. If the vehicle cabin becomes too humid and recirculated air is selected, the FCIM adjusts the air inlet door to allow more fresh air. When the humidity level drops, it may adjust back to partial recirculated air. The FCIM also adjusts the system based on in-vehicle temperature.