Pinpoint Test D : Unable To Program Keys
- D1 CHECK THE RFA (REMOTE FUNCTION ACTUATOR) MODULE DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE SELF-TEST
- Ignition ON.
- Using a diagnostic scan tool, carry out the RFA module self-test.
Is any DTC other than B10D7:05 present?
Yes RESOLVE these Diagnostic Trouble Codes (DTCs) first. REFER to the RFA DTC Chart . No GO to D2 - D2 CHECK THE PASSIVE KEY
- Verify the correct passive key is used with the vehicle. Refer to the parts catalog.
Is the correct key used?
Yes ATTEMPT to program the key again. REFER to: Key Programming Using Diagnostic Equipment . If key programming fails, GO to D3 No OBTAIN the correct key for the vehicle. PROGRAM the new key. REFER to: Key Programming Using Diagnostic Equipment . - D3 PROGRAM A SECOND PASSIVE KEYNOTE: This step requires a second passive key. If only one key is available, a second passive key must be obtained.
- ATTEMPT to program a new valid passive key. REFER to: Key Programming Using Diagnostic Equipment .
Does the new key program to the vehicle?
Yes DISCARD the damaged key in question. No INSTALL a new PATS front antenna. REFER to: Passive Anti-Theft System (PATS) Front Antenna .