Pinpoint Test Ac : U0140:00: Notes

WARNING: This page is about a different variant/trim than selected.

Refer to Module Communications Network for schematic and connector information.

Normal Operation and Fault Conditions

The PCM continuously monitors the CAN for messages from the BCM. This DTC sets when the PCM does not receive the BCM message within the defined amount of time.

Possible Sources

Connectors damaged or pushed-out terminals, corrosion, loose wires and missing or damaged seals
Communication error
Low battery condition
Battery recently replaced
BJB fuse 41 (20A)
High current BJB mega fuse 4 (50A)
High current BJB mega fuse 9 (50A)
ABS module
PCM

DTC Fault Trigger Conditions

DTC	Description	Fault Trigger Conditions
U0140:00	Lost Communication With The Body Control Module (BCM)	After the PCM, BCM wake up the PCM did not detect a response from the BCM.