July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Inspection and Verification

NOTE: For most AWD System DTC to set, the AWD module must detect the fault on 2 consecutive trips.

1) Record and clear DTC from the AWD Module.

2) Accelerate the vehicle from 0-45 mph with light (10%) APP.

3) Maintain 45 mph for 10 seconds.

4) Gently slow to a stop.

5) Repeat steps 2-4.

6) Accelerate the vehicle from 0-45 mph with moderate (30%) APP.

7) Maintain 45 mph for 10 seconds.

8) Gently slow to a stop.

9) Repeat steps 6-8.

10) Turn off ignition, wait 1 minute.

11) Repeat steps 2-9 or until an AWD fault message is displayed in the IP. Whichever is sooner.

12) Retrieve continuous memory DTC from the AWD Module. If no DTC are present, the concern may be intermittent. Do not perform a pinpoint test unless the concern is present.