Pinpoint Test Ag: Module Configuration Fault
- DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition HVAC U2024:51 Control Module Cal-Config Data: Not Programmed This DTC sets due to incomplete or improper PMI procedures. HVAC U2100:00 Initial Configuration Not Complete: No Sub Type Information This DTC sets due to incomplete or improper PMI procedures. Possible Sources
- Incomplete or incorrect PMI
- AG1 CARRY OUT THE PMI (PROGRAMMABLE MODULE INSTALLATION) FOR THE SUSPECT MODULE
- Ignition ON.
- Using a diagnostic scan tool, carry out the PMI procedure for the suspect module as directed by the diagnostic scan tool.
- Using a diagnostic scan tool, clear the Diagnostic Trouble Codes (DTCs) for the suspect module.
- Using a diagnostic scan tool, carry out the self-test for the suspect module.
Is the original DTC still present?
Yes INSTALL a new HVAC control module. REFER to: Heating, Ventilation and Air Conditioning (HVAC) Control Module . No The repair is complete.