Cruise Control Operation

WARNING: This page is about a different car, the 2022 Ford Police Interceptor Utility and 2022 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

The cruise control functions include:

turning on the cruise control system.
setting and maintaining the desired vehicle speed.
accelerating the vehicle speed.
coasting down to a lower speed.
resuming the prior vehicle speed.
turning off the cruise control system.

The cruise control system maintains a selected vehicle speed within a range between 32 km/h (20 mph) or 30 km/h (18 mph) if equipped with a metric cluster and the maximum limited vehicle speed. When a MyKey® restricted key is in use, the vehicle speed will not exceed the MyKey® maximum limited speed. During normal driving conditions, the vehicle speed can fluctuate slightly from the selected set speed due to road conditions. The vehicle speed can fluctuate more noticeably when driving up and down steep hills.

Certain conditions cause the cruise control system to deactivate:

Application of the parking brake.
Transmission gear selector is placed into a position other than D.
Cruise control set speed is overridden with the accelerator pedal for a period longer than 5 minutes.
Cruise control switch is pressed or stuck longer than 2 minutes.
Vehicle speed decreases more than 16 km/h (10 mph) below the set speed.
ABS fault.

The BPP switch assembly (contains the stoplamp switch and cruise control deactivator switch) and APP sensor are hardwired inputs to the PCM.

Electronic Throttle Body (ETB) command is a hardwired output of the PCM.

The vehicle speed is controlled by the PCM through the Electronic Throttle Control (ETC) subsystem.

The cruise control system provides self-diagnostics. Cruise control is disabled anytime an error is detected in the system. No IPC indicator or message center messages are displayed when faults occur. Fault codes are logged by the PCM or SCCM.

An Electronic Throttle Control (ETC) system fault also causes the cruise control system to be disabled. In this case, an Electronic Throttle Control (ETC) system powertrain malfunction (wrench) warning indicator is displayed.

Cruise Control Indicator

The cruise control indicator, located in the IPC, illuminates to indicate the cruise control system is active.

Steering Wheel Switch Function

Cruise control switch inputs are received by the SCCM and sent to the PCM through the GWM on the HS-CAN1.

Pressing ON and releasing the ON/OFF switch turns the cruise control system on. Pressing SET+ or SET- on the SET switch while the vehicle is traveling at the desired speed activates the cruise control system.

Pressing up or down on the SET switch while in the active mode increases or decreases the maintained vehicle speed by 1 km/h per press when displayed units are "km/h" and 1 mph per press when displayed units are "mph". If the respective switch is pressed and held, the vehicle speed continues to accelerate or decelerate until the switch is released.

Pressing OFF and releasing the ON/OFF switch or turning the ignition switch to the OFF position, turns the cruise control system off. While the cruise control system is active, applying the brake or pressing the CNCL (CANCEL) switch puts the cruise control system into standby mode. Pressing the RES (RESUME) switch when the cruise control system is in standby mode causes the vehicle to accelerate to the last set speed. Resume does not function if the OFF switch is pressed, the ignition switch is cycled off or if the current vehicle speed is below the minimum operational speed.