Ignition System: Distributor: Removal
WARNING: This page is about a different car, the 1995 Dodge Ram Wagon, 1995 Dodge Ram Van, 1995 Dodge Pickup, and 1995 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect distributor pick-up connector from wiring harness connector. Remove splash shield (if equipped). Remove distributor cap. Rotate crankshaft until distributor rotor is pointing toward cylinder No. 1 terminal of distributor cap.
- To indicate rotor and distributor housing position when reinstalling distributor, scribe mark on distributor or adjacent component as reference. Remove distributor hold-down nut. Carefully lift distributor from engine.