LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 1993 >> Yukon Automatic >> Repair and Diagnosis >> Body & Frame >> Power Windows >> Removal & Installation >> Door Module >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Door Module: Removal

  1. Remove door trim panel. See DOOR TRIM PANEL  . Lower the window all the way down.
  2. Remove screws holding the module to the door. Pull back the water deflector.See Fig 1 .
    Fig 1: Identifying Door Module Components
    G00125832Courtesy of GENERAL MOTORS CORP.
  3. Disconnect lock and handle rods from the back of the module. Tape them to the door.
  4. Disconnect module wiring connector, if present. Pull the wiring from the door hinge pillar to reach the connector. Remove the boot over the wiring. Push the wiring harness into the door.
  5. Remove upper belt through window run channel, see Fig 2 . Move the channel away from the glass. Tilt the module and window glass assembly and lift it out of the bottom of the door.
    Fig 2: Removing Glass Run Channel
    G00125833Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals