LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 1995 >> Forward Control 7.4 N >> Repair and Diagnosis >> External Pages >> Different car >> Section 126 (Engine Controls - Remove/Install/Overhaul - 5.0L) >> Powertrain Control Module (Pcm) >> Mem-Cal >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Powertrain Control Module (Pcm): Mem-Cal: Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 1995 GMC Vandura, 1995 GMC Rally, 1995 GMC Pickup, 1995 Chevrolet Sportvan, and 1995 Chevrolet Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Carefully align MEM-CAL pins with PCM pin holes. DO NOT press in middle of MEM-CAL. Push downward evenly on ends of MEM-CAL until retaining clips on ends of MEM-CAL snap into place.
  2. Install PCM. Reconnect negative battery cable. Turn ignition on and ground DLC terminal "B". DTC 12 should be flashed at least 4 times. If DTC 12 is not flashed at least 4 times, other codes are present. If DTC 51 is present, or if MIL stays on constantly with code(s) present, MEM-CAL is not fully seated, or is defective.
scientia non olet · About LEMON Manuals